846665 - Subaru Redline Fuse Box Cover VB WRX

2022 - 2024 WRX

Congratulations on your purchase of the COBB Tuning Subaru Redline Fuse Box Cover! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.

Parts List

Redline Fuse Cover Driver Side

Redline Fuse Cover Passenger Side

Pre-Cut Adhesive Sheet

Tools Needed

Misc.

Hands
Soap
Water
Towel

Installation

Park your car in a flat, level area and allow it to cool down properly.
Locate your fuse boxes in the engine bay.
If they're dirty (Like ours) take it off of the car by depressing the clips and lifting. Then wash it thoroughly with soap and water, making sure to get all the soap residue off of the cover, and allow it to dry completely before proceeding
Remove the cover from the foam it came in and flip it upside down, setting it on top of the foam.
Pop the center out of the adhesive sheet
The larger gasket will go on the big cover, while the smaller inner part of the gasket will match up with the smaller cover. Line it up with the indentation on the lids to make sure of the orientation. Armed with the knowledge, remove the backing from the side that will go towards the cover and stick it down in place.
Remove the side of the adhesive that is towards the cover and attach it to the cover pressing down firmly.
Remove the top layer covering the adhesive to expose the sticky side
Drop the factory covers down into the carbon piece and gently press in the area where the adhesive is.
You're all done! Go out and enjoy