VA WRX, STI Front Swaybar End Links
CB-1225 – COBB VA WRX, STI Front Sway Bar Endlinks
2007 - 2011 Subaru Impreza WRX, WRX STI
2015 - 2021 Subaru WRX, WRX STI
Congratulations on your purchase of the COBB Tuning Rear sway bar endlinks! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.
Table of Contents
- 1 Table of Contents
- 2 Parts List
- 3 Tools Needed
- 3.1 Sockets
- 3.1.1 3/8"
- 3.2 Hand Tools
- 3.3 Wrenches
- 3.1 Sockets
- 4 Stock Swaybar Removal
- 5 Installation
- 6 Links
Parts List
Tools Needed
Sockets
3/8"
3/8" ratchet
3/8" 12" extension
3/8" 6" extension
3/8" 12mm socket
3/8" 14mm socket
Hand Tools
5mm Allen Key
6mm allen Key
Flatblade Screwdriver
Wrenches
14mm combination wrench
17mm combination wrench
Stock Swaybar Removal
Park your car in a flat, level area and allow it to cool down properly.
Using a 10mm wrench, remove the negative terminal of the battery.
Jack your car up and support it properly, either using a lift, ramps, or jack and jack stands.
Lay a blanket or cardboard down under the car, or grab a creeper. In this case his name is Andrew
Use a 17mm wrench to undo the nut while using a m6 allen wrench to hold the center of the endlink and keep it from spinning. Break each side loose first (sway bar and control arm) and then remove the nut completely. Repeat with the other side.
With the end links loosened on both side, undo the two 12mm fasteners holding the sway bar to the subframe and drop it out of the car.