746170 - VB WRX Redline Carbon Fiber Fender Shroud

2022-2024 Subaru WRX

Congratulations on your purchase of the COBB Tuning Redline Fender Shroud The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.

[ 1 Parts List ] [ 2 Tools Needed ] [ 2.1 Sockets ] [ 2.1.1 3/8" ] [ 2.2 Hand Tools ] [ 2.3 Wrenches ] [ 3 Stock Component Removal ] [ 4 Fender Shroud Installation ] [ 5 CARB Sticker Application ]

Parts List

Tools Needed

Sockets

3/8"

3/8" ratchet
3/8" 13mm socket

Hand Tools

Trim removal tool

Wrenches

13mm combination wrench

Stock Component Removal

Park your car in a flat level area. While you aren’t working on anything hot, there are other things in your engien bay that may be warm, so it may be advisable to wait until the car cools down before working on this installation.
Remove the three trim clips holding the fender shroud in place. To do so use your trim tool (or screwdriver) to gently liftthe center tab of the pin upward until it stops. Once that’s loosened place your trim removal tool under the base of the trim clip and lever it outward to remove it from the metal panel under the trim.
Gently remove the fender shroud from the engine bay. It should come out fairly easy.

Fender Shroud Installation

Hardware goes to the original positionsthe trim clips were fitted in this order where top to bottom is front to back on the car (j-clip at the top on the headlight, shorter standoff set at the back)

The front-most point where the fender shroud was installed (on the headlight bracket), install one of the metal j-clips with the threaded part on the bottom.
In the middle point install the Tall standoff using a washer on both side and a nut on the bottom. Use two 13mm devices (I used a socket on the top and a wrench on the bottom). And tighten it down.
In the rearmost hole where it was oroginally installed, pop in the shorter standoff again, using a washer on either side, and a nut on the bottom.
Gently slide the fender shroud into place around the lift support and line up the holes.
Using the provided Allen key, secure the shrouds with the short Allen bolts and nylon washers for the rear two holes, and the longer bolt and remaining washer for the front position in the j-clip. It’s a good idea to get them all started before tightening them down finger tight.

Hardware order, top to bottom in picture is front to back on the car.
You’re all done! Go out and enjoy!