VA WRX, STI Front Swaybar End Links

CB-1225 – COBB VA WRX, STI Front Sway Bar Endlinks

2007 - 2011 Subaru Impreza WRX, WRX STI
2015 - 2021 Subaru WRX, WRX STI




Congratulations on your purchase of the COBB Tuning Rear sway bar endlinks! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.




Table of Contents




Parts List

 Front Swaybar Endlinks

 Hardware



(8) M12 Washers
(4) M12 Nuts

Tools Needed

  • 3/8" ratchet
  • 3/8" 12" extension
  • 3/8" 6" extension
  • 3/8" 12mm socket
  • 3/8" 14mm socket


  • 5mm Allen Key
  • 6mm allen Key
  • Flatblade Screwdriver
  • 14mm combination wrench
  • 17mm combination wrench




Stock Swaybar Removal

  1. Park your car in a flat, level area and allow it to cool down properly.

  2. Using a 10mm wrench, remove the negative terminal of the battery.

  3. Jack your car up and support it properly, either using a lift, ramps, or jack and jack stands.

  4. Lay a blanket or cardboard down under the car, or grab a creeper.  In this case his name is Andrew




  5. Use a 17mm wrench to undo the nut while using a m6 allen wrench to hold the center of the endlink and keep it from spinning.  Break each side loose first (sway bar and control arm) and then remove the nut completely.  Repeat with the other side.






  6. With the end links loosened on both side, undo the two 12mm fasteners holding the sway bar to the subframe and drop it out of the car.





Installation



  1. Loosely slip your end links into the sway bar and control arms on each side.  There should be a washer on either side of what you're attaching through.






  2. Now you will want to drop the car back down on it's wheels.  If you have ramps or stands that are designed to support the vehicle on it's wheels safely, now is a good time to use them.

  3. To adjust the endlinks properly you'll want to ensure that the sway bar isn't going to hit anything through it's range of travel, and that the threaded portion of the end link on both sides is relatively close to 90°.  To do so you may need to take out one end of the end link and rotate it to make the end link longer or shorter.






  4. Once you"re happy with the length, go ahead and tighten the end link to the control arm and sway bar.  Then hold the body of the end link in place with a 16mm before tightening the jam nut on the end link to prevent the body from rotating any more.

  5. Go out and Enjoy!




Links



Contact Us:

COBB Customer Support

Web Support and Tech Articles: COBB Tuning Customer Support Center

Email: support@cobbtuning.com

Phone support available 9am to 6pm Monday-Thursday. 9am to 4pm Friday (CST)

866.922.3059


return to www.cobbtuning.com

Copyright 2024 © COBB Tuning Products LLC. All Rights Reserved. | www.cobbtuning.com