How To: Change Datalog Monitors

Applicable Model/Year: 

• All Vehicles

How To Enable:

This feature comes pre-enabled on all Accessport-compatible vehicles.

V3

Steps to Use:

How To Change Number Of Parameters Displayed

1. Link your Accessport to your vehicle and turn it on.
2. Select "Gauges" from the main menu
3. Go up and select "Setup"
4. Select "Configure Datalogging"
5. Select/de-select parameters you want to be logged
6. When finished simply hit the back button to return to the gauges
   
   

How to Change Datalogged Monitors

1. Link your Accessport to your vehicle and turn it on.
   
   
2. Select Gauges from the main menu
   
   
   
   
3. Go up and select Settings, then go to Configure Datalogging
   
   
   
   
4. You'll now see a list of monitors to select or deselect at will.  If you exceed what the ECU is capable of logging at a reasonable rate, the AP will give you a warning message to remove parameters.  Some parameters may take more memory to log than others.
   
   
   
   
   
5. On the monitor select screen you can also scroll up to Setup for a few options.
   1. Select Clear monitors to clear all
   2. Reset to Defaults to go back to the default
   3. Save a Datalog Preset Saves your current logged items so you can load it again later.
   4. Load a Datalog Preset lets you load a custom log list you saved, or were sent by a tuner/COBB and loaded onto the AP through Accessport Manager
6. When finished simply hit the back button to return to the gauges

V2

1. Navigate to the "Monitor" menu
   
   
   
   
   
2. Select "Set Data Log List"
   
   
   
   
   
3. Select/deselect monitors to datalog.
   
   
   
   
4. Press the Cancel button to exit. A prompt is shown to confirm or cancel changes.
   
   

Related Articles:

How To: Datalog

• BMW Datalogging Guide
• Mazda Datalog Guide
• Mitsubishi Datalogging Guide
• Nissan GTR Datalog Guide
• Porsche Datalogging Guide
• Subaru Datalog Guide
• Volkswagen Datalog Guide