WRX/STI EJ Stock Intake Removal

Remove the (2) plastic retainers that hold down the intake snorkel using a flat head screwdriver.
Remove the intake snorkel from the engine bay.
Remove the (2) Phillips head screws holding down the MAF sensor using a Phillips head screwdriver.
Gently remove the MAF sensor and unclip the MAF sensor harness then set the sensor somewhere safe.
Release the vacuum hoses from the clips on the intake elbow.
Loosen the (2) hose clamps on the intake elbow.
Remove the 10mm bolt that holds the bottom of the airbox to the chassis using a 10mm socket and 6" extension.
Remove the 10mm nut holding the airbox to the airbox bracket.
Gently lift and remove the airbox, being cautious of the other vacuum hoses in the engine bay.

Customer Support Center