772625 - Mazdaspeed3 Gen2 Front Mount Intercooler
772625 – Mazdaspeed3 Gen2 Front Mount Intercooler
Mazda3 MPS 2010 - 2012
Mazdaspeed Axela 2010 - 2012
Mazdaspeed3 2010 - 2013
Congratulations on your purchase of the COBB Tuning Mazdaspeed Gen 2 Intercooler! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.
IMPORTANT! Installing this kit will require custom tuning or utilizing an appropriate Stage Power Package map if you have a matching mechanical configuration. Please consult with COBB or an authorized ProTuner in your area if you have any questions!
Table of Contents
Parts List
Intercooler Core
(2) Intercooler Mounting Brackets
(3) Intercooler Charge Pipes
90 Degree Silicone Reducer
2.75" - 2.5"
(3) 2.5" Straight Couplers
(8) 2793T-Bolt Clamp 70-78mm
2792 T-Bolt Clamp 60-68mm
2794 T-Bolt Clamp 73-81mm
Stencil for MS3 FMIC
Shift Wight
Pipe Sticker for MS3 FMIC
(4) 1/4" - 20 Cap Screws
(4) 1/4" Lock Washers
(2) M8 - 1.25 x 16 Cap Screws
(2) 8mm Lock Washer
Tools Needed
Phillips head screwdriver
Flathead screwdriver
3/8" ratchet
3/8" 8mm socket
3/8" 10mm deep socket
3/8" 12" extension
3/8" 6" extension
10mm combination wrench
12mm combination wrench
Razor Knife or snips to cut plastic
Before You Begin
We suggest checking with the dealer to see if your car may be a candidate for the Mazda recall on one or more of the engine mounts, or invest in some stiffer after market engine mounts before starting on the installation of the COBB FMIC. Excessive engine movement may cause a properly fitting kit to rub
Copyright 2025 © COBB Tuning Products LLC. All Rights Reserved. | www.cobbtuning.com