Open

Congratulations on your purchase of the COBB Tuning Intake Bracket! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.

Parts List

Bottom Support Bracket

Open

 

 

Top Support Bracket

 

(2) COBB Plastic Washers

 

Tools Needed

Sockets

3/8"

• 3/8" ratchet

• 3/8" 8mm socket

Hand Tools

• 4mm Allen Key

• Trim removal tool

 

Wrenches

• 8mm combination wrench

Stock Intake Scoop Removal

1. Park your car in a safe area that is flat and level.
   
   

2. Remove the two trim clips holding the snorkel in place on the core support. Pull the center part of the clips out with your trim tool until they click and then pull out the lower part.
   
   

    

   
   
   

3. Remove the other trim clips that hold the plastic cover over the upper grill area. That cover can then be removed.
   
   

    

   
   
   

4. Grab your 8mm socket or wrench and remove the small bolt holding the intake scoop to the intake, then the snorkel can be removed from the engine bay.
   
   

   
   
   

COBB Intake Brace Installation

1. The silver lower half of the brace will line up in front of the AC condensor with the short bent tabs on the top grabbing the lip of the core support. You’ll slip it in front, flexing it a little bit with your fingers to get it around the round part. It’s usually easiest to get both legs into position and then gently push towards yourself in the middle to get it around the AC condensor.
   
   
   

   
   
   

   
   
   

    

    

    

2. Line the leg on the driver’s side up with the push clip holding the rubber airflow panel to the core support. Supporting the back side of the brace with a finger push it on to the clip to hold it in place. If you see the start of the threaded hole through the hole on top you’ll know you’re on the right track for meeting up with the clip. In some cases it can be easier to remove the clip and reinstall with
   
   
   

   
   
   

   
   
   

    

   
   
   
   

   
   
   

   
   
   

3. The threads should now line up with the two holes in the core support, with the tabs on the back holding it onto the core support.
   
   

   
   
   

4. You can now reinstall the cover but leave the trim clips off for now so you can get things lined up.
   
   

   
   
   

5. Using the supplied allen bolts and plastic washers, install the top bracket into the scoop but leave them a little loose.
   
   

   
   
   

6. Put in all of the trim clips to hold the upper cover in place, then tighten down the two bolts for the brace using the supplied 4mm allen key.

   
   
   

7. You’re all done! Go out and enjoy!

CARB Sticker Application

(Where Applicable)

1. Apply the supplied CARB sticker in a clear, easy to find location.  Typically underhood, or on the radiator core support.

Links

Gen3 Raptor Issues: Intake Collapse

Raptor ECU Removal and Shipping

Map Notes for Gen3 Raptor