Engine Monitor List for BMW Vehicles: N54 & N55
BMW N54 & N55 Monitor List
AP-BMW-001 & AP-BMW-002 Data Monitors
BMW N54 AP-BMW-001 Gauges and Data Monitors
**Bolded Monitors indicate default data log parameter
- Accel Ped. Pos. - (%)
- Actual Load - (Load)
- Baro Pressure - (PSI, kPA, kPA)
- Battery Voltage - (V)
- Boost - (PSI, kPA, kPA)
- Boost Mean Abs - (PSI, kPA, kPA)
- Boost Set Limit - (PSI, kPA, kPA)
- Boost Setpoint Factor - (Factor)
- Charge Air Temp. - (°F, °C, °C) (N54)
- Cyl1 Timing Cor
- Cyl2 Timing Cor
- Cyl3 Timing Cor
- Cyl4 Timing Cor
- Cyl5 Timing Cor
- Cyl6 Timing Cor
- ECT - Engine Coolant Temperature (°F, °C, °C)
- Fuel HPFP - (PSI, kPA, kPA)
- Fuel HPFP (Req.) - (PSI, kPA, kPA)
- Fuel LPFP - (PSI, kPA, kPA)
- Fuel LPFP (Req.) - (PSI, kPA, kPA)
- Fuel Mode - (Mode)
- Intake Manifold Temp (N55)
- IPW Cyl 1 - (%)
- IPW Cyl 2 - (%)
- IPW Cyl 3 - (%)
- IPW Cyl 4 - (%)
- IPW Cyl 5 - (%)
- IPW Cyl 6 - (%)
- Knock Volt Cyl. 1 - (V)
- Knock Volt Cyl. 2 - (V)
- Knock Volt Cyl. 3 - (V)
- Knock Volt Cyl. 4 - (V)
- Knock Volt Cyl. 5 - (V)
- Knock Volt Cyl. 6 - (V)
- Lambda (Bank1) - (AFR, λ, λ)
- Lambda (Bank2) - (AFR, λ, λ)
- Lambda Req. (Bank1) - (AFR, λ, λ)
- Lambda Req. (Bank2) - (AFR, λ, λ)
- Load Requested - (Load)
- LTFT (Bank 1) - (%)
- LTFT (Bank 2) - (%)
- MAF - (g/s)
- MAP - (?)
- Oil Temp. - (°F, °C, °C)
- Req. Boost Abs. - (AFR, λ, λ)
- Req. Boost Delta - (AFR, λ, λ)
- RPM - (RPM)
- STFT (Bank 1) - (%)
- STFT (Bank 2) - (%)
- Timing Cor. (BAT/ECT) - (°)
- Timing Cyl. 1 - (°)
- Timing Cyl. 2 - (°)
- Timing Cyl. 3 - (°)
- Timing Cyl. 4 - (°)
- Timing Cyl. 5 - (°)
- Timing Cyl. 6 - (°)
- Torque Limit Active - (?)
- Torque Limit Modifier - (?)
- Torque Output - (%)
- Torque Requested - (%)
- TPS Act. - (%)
- VANOS Exh. Act. (CRK) - (CA)
- VANOS Exh. Req. (CRK) - (CA)
- VANOS In. Act. (CRK) - (CA)
- VANOS In. Req. (CRK) - (CA)
- Vehicle Speed - (mph, kph, kph)
- WGDC After PID (CRK) - (%)
- WGDC Bank 1 - (%)
- WGDC Bank 2 - (%)
- WGDC Base Value - (%)
N55: 2011 BMW 135i, 335i Data Monitors
**Bolded Monitors indicate default data log parameter
- Battery Voltage (V)
- Vehicle Speed
- MAF
- RPM
- Pedal Position
- TPS Actual
- TPS Requested
- Baro Pressure
- Boost Abs Post TB
- Torque Output
- ECT
- Oil Temp
- Ambient Temp
- Charge Air Temp
- Lambda
- STFT
- LTFT
- O2 Sen Pre Cat (V)
- O2 Sen Post Cat (V)
- Boost Rel.
- Boost Abs. TB. (Tuning)
- Boost Req. Abs. TB. (Tuning)
- Boost Over Shoot Factor
- Boost Set Limit
- Boost Ratio (TPS)
- Load Act.
- Load Req.
- Load Max
- MAF Req. (WGDC)
- MAF Req.
- WGDC
- WGDC Base Value
- WGDC After PID
- Torque Request
- Timing Cor. Cyl 1
- Timing Cor. Cyl 2
- Timing Cor. Cyl 3
- Timing Cor. Cyl 4
- Timing Cor. Cyl 5
- Timing Cor. Cyl 6
- Timing Cyl 1
- Timing Cyl 2
- Timing Cyl 3
- Timing Cyl 4
- Timing Cyl 5
- Timing Cyl 6
Copyright 2024 © COBB Tuning Products LLC. All Rights Reserved. | www.cobbtuning.com