7F1100, 7F2100, 7F3100 - F150, F150 Raptor SF Intake
Congratulations on your purchase of the COBB Tuning Ford Raptor SF Intake! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.
IMPORTANT! Installing this kit will require custom tuning or utilizing an appropriate Stage Power Package map if you have a matching mechanical configuration. Please consult with COBB or an authorized ProTuner in your area if you have any questions!
Table of Contents
Parts List
COBB AirBox Lid
Air box gasket
Air Filter Assembly
Passenger Intake Tube
Driver Intake Tube
3" Coupler
4" - 3" Reducer Coupler
Intake Tube Bracket
M4 Hex Key
#64 Hose Clamp
3 x #48 Hose Clamp
4 qty. M6 x 12mm Button head cap screw
Tools Needed
Hand Tools
Phillips head screwdriver
Flathead screwdriver
7mm Nut Driver
Trim removal tool
Optional Tornaderz Flux Swirl Generator Removal
At this time if you decide to you can easily remove the swirl generators found in the two intake tubes. The large one seems to pull out easily by hand while the smaller one may require a screwdriver to pull free. While we cannot guarantee this will have no impact on your vehicle, we have found it only to contribute to a reduction in intake noise.