7C1665 - GT-R LF BPV

COBB Tuning BPV Installation Instructions

7C1665 – Nissan GT-R LF BPV

2009-2019 Nissan GT-R




Congratulations on your purchase of the COBB Tuning BPV! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.




Table of Contents




Parts List


  • BPV
  • (3) feet of 6mm vacuum hose
  • Zip Ties

Tools Needed



Stock BPV Removal

  1. With your car parked in a flat, level area and cooled down, Locate the BPV on each side.



  2. Using your needle nose pliers squeeze the factory spring clamps and slide the clamp up the hose.



  3. Go ahead and unbolt the BPV using a 12mm socket.  Making sure not to lose the factory gasket, pull the BPV free from the two rubber hoses and remove it from the car.



  4. Using your pliers, remove the other end of the BPV's intake manifold reference line.

        


COBB BPV Installation

  1. Push the nose of the BPV into the stock recirculation hose.



  2. Now go ahead and bolt it in place using the stock 12mm bolts.

  3. With it bolted in, install the supplied silicone vacuum line to the BPV using the factory spring clamps.  If necessary turn the top fitting and re-torque to 60 ft-lbs



  4. Now go ahead and hold the hose up to the fitting on the manifold to get an idea of where to cut it.



  5. With it measured, go ahead and cut it before installing the hose with the other factory spring clamp.



  6. You're all done!  Go out and enjoy.





Contact Us:

COBB Customer Support

Web Support and Tech Articles: COBB Tuning Customer Support Center

Email: support@cobbtuning.com

Phone support available 9am to 6pm Monday-Thursday. 9am to 4pm Friday (CST)

866.922.3059