Map Notes for ADM VB WRX MT
Â
Supported Vehicles
Subaru WRX MT 2024
Map Revisions:
Map | Version |
---|---|
Stage0 | v301 |
Stage2 | v311 |
Required Accessport Firmware
AP3-AU-SUB-006:1.7.5.0-25910
Â
Map Availability:
All maps come pre-installed on the Accessport. Download maps via theÂ
Â
Â
Fuel Requirements:
Each map lists the minimum required octane. A higher octane fuel can be used safely on a map designed for lower octane. DO NOT use maps designed for higher octane with lower octane fuels. Top Tier gasoline should be used where available.
Maps designated with "ACN91 OCT or 93 RON" are for use with 91 octane fuel found in Arizona, California, and Nevada, Canadian 94 Octane and 94 Octane with 0% ethanol, 93 RON fuel or better.
Maps designated with "91 OCT or 95 RON " are for use with 91 and 92 octane/95 RON fuel or better.
Maps designated with "93 OCT or 98 RON" are for use with 93 octane/98 RON fuel or better.
94 octane with 0% Ethanol should run the ACN91 Map.
Â
Running 0% Ethanol Fuels
These maps are designed for E10 fuel (fuel with 10% ethanol content). For those who only have access to E0 fuel (fuel with 0% ethanol) it is recommended to use the "91" and "ACN91" octane versions of the maps and datalog the car to ensure your fuel is performing to the necessary level. This is especially important for those using Canadian 94 octane E0 fuel.Â
Â
Â
Peak Increase compares the highest value present for each run regardless of RPM
Max HP/TQ is the largest difference when comparing stock vs tuned at a single RPM point
Average HP/TQ refers to the average value present over the entire RPM range
Â
Â
VB WRX MT Power Output
Stage1 Hard Parts Requirements
Exhaust Requirements:Â Stock or upgraded catback exhaust.
Intake Requirements: Stock air box and filter
Intercooler Requirements: Stock
Boost Level
93 Octane 98 RON Minimum:Â ~15.2psi peak boost pressure tapering down as you approach redline, +/- 1.5psi.
91 Octane 95 RON Minimum:Â ~14.2psi peak boost pressure tapering down as you approach redline, +/- 1.5psi
Stage2
Stage2 Hard Parts Requirements
Exhaust Requirements:Â Stock or upgraded catback exhaust.
Intake Requirements:
Stock air box and filter
COBB Aluminum Intake Tube - 746100
COBB FA24 Charge Pipe - 746110
Intercooler Requirements:
COBB Top Mount WRX Intercooler - B41450
Boost Level
93 Octane 98 RON Minimum:Â ~18.2 psi peak boost pressure tapering down as you approach redline, +/- 1.5psi.
91 Octane 95 RON Minimum:Â ~17.4 psi peak boost pressure tapering down as you approach redline, +/- 1.5psi
Non-Performance Maps
Stage1 Economy
Fuel Requirements:Â 91 octane or better
Intake Requirements: Stock airbox and stock air filter
Exhaust Requirements: Stock exhaust
Boost Targets: Mechanical minimum
Not Intended for Aggressive/Spirited Driving
Anti-Theft Mode
Once Flashed will prevent the vehicle from starting
Â
Stage0
A map with stock calibration for diagnostic use
Engine Oil Temp Safety
OTS maps have oil temperature safety enabled. Above a temperature of 250°F maximum power will be reduced to reduce the potential for damage caused by excessive oil temperature. Power will be restored once oil temperature falls to a safer level.
Closing Warnings and Precautions:
Use of inappropriate calibration/modification combinations will promote engine damage.
Top Tier gasoline should be used where available. Use of lower quality fuels can result in catastrophic engine damage.
For track events, we recommend adding at least 2 gallons of 100 octane fuel to battle high track temperatures.
Â
Â
Version | Notes |
---|---|
v311 | Added stage2 map |
v301 | Tweaks to part throttle driveability to reduce (not remove) the likelihood of minor knock. Slight power increase. |
v300 | Patch to OEM code to reduce likelihood of ecu bricking on subsequent flashes. |
v210 | Added Fast Flash |
v110 | Initial Release |
Copyright 2024 © COBB Tuning Products LLC. All Rights Reserved. | www.cobbtuning.com