COBB Custom Features: Burnout Mode on MQB Vehicles

How To Enable:

This feature is enabled on all OTS Maps

The vehicle will need to meet the following conditions for the ECU to allow it to happen.

• Coolant Temp Min-Max (160F - 250F)
• Engine Oil Min-Max (160F - 250F)
• EGT MAX (1835F)
• Steering Wheel Angle (within 20 degrees of being completely straight)

Steps to Use:

Golf R Will need to be set to "Dyno Mode" in order to disable the rear axle.  If enabled the car will essentially just launch itself with a higher RPM than launch control would otherwise allow.
How to: Put MK7 Golf R in "Dyno Mode" (FWD)

Manual Transmission

• Engage the parking brake
• Enable cruise control
• Press and hold the cruise control "set" button
• Depress and hold the clutch pedal to 100%
• Move the shifter to 1st gear
• Depress and hold the throttle pedal to 100%
• Release the clutch pedal
• Continue to hold the "set" button for as long as you'd like to do the burnout

DSG Transmission

• Engage the parking brake
• Enable cruise control
• Press and hold the cruise control "set" button
• Depress and hold the brake pedal to 100%
• Move the shifter to Sport Mode
• Depress and hold the throttle pedal to 100%
• Release the brake pedal
• Continue to hold the "set" button for as long as you'd like to do the burnout

Things To Look Out For:

Related Articles:

COBB Custom Features: Launch Control on MQB Vehicles

COBB Custom Features: How to Use Flat Foot Shift on MQB Vehicles

Customer Support

support@cobbtuning.com

Phone support available 9am to 6pm Monday-Thursday. 9am to 4pm Friday (CST)

866.922.3059