Audi S3 (8V) 2019-2020

Supported Vehicles:

  • USDM 2019 - 2020 Volkswagen Audi S3

 


Map Revision:

Map

Version

Map

Version

Stage0
Stage1
Stage2

v301

Stage1+Flex Fuel

v302

Required Accessport Firmware: 

  • AP3-VLK-003: 1.7.4.2-24849

Map Availability: 

 

For more information on CARB Exemption Orders for this vehicle as well as the actual letter check out our page https://cobbtuning.atlassian.net/wiki/spaces/PRS/pages/2169241668


COBB Custom ECU Features:

These cars offer a variety of added features such as launch control and traction control. For more information check out our guide https://cobbtuning.atlassian.net/wiki/spaces/PRS/pages/228491644

 


 

Fuel Requirements:

Each map lists the minimum required octane. A higher octane fuel can be used safely on a map designed for lower octane. DO NOT use maps designed for higher octane with lower octane fuels. Top Tier gasoline should be used where available.

  • Maps designated with "91 OCT or 95 RON " are for use with 91 and 92 octane/95 RON fuel or better.

  • Maps designated with "93 OCT or 98 RON" are for use with 93 octane/98 RON fuel or better.

    • 94 octane with 0% Ethanol should run the ACN91 Map.

 

Running 0% Ethanol Fuels

These maps are designed for E10 fuel (fuel with 10% ethanol content). For those who only have access to E0 fuel (fuel with 0% ethanol) it is recommended to use the "91" and "ACN91" octane versions of the maps and datalog the car to ensure your fuel is performing to the necessary level. This is especially important for those using Canadian 94 octane E0 fuel. 

 

 


 

Stage1 Power Output

Stage 1 Maps

  • CARB EO: D-660-37

  • Intake Requirements : 

  • Exhaust Requirements: Stock exhaust or upgraded cat-back exhaust

  • Fueling Requirements: COBB Flex Fuel Upgrade Kit 3V2650

  • Boost Target:

    • 91 Octane 95 RON Minimum: ~21 psi peak boost pressure tapering down to 16~ psi as you approach the 6800RPM redline, +/- ~1.5psi.

    • 93 Octane 98 RON Minimum: ~22 psi peak boost pressure tapering down to ~16psi as you approach the 6800RPM redline, +/- ~1.5psi.


Stage1+Flex Fuel

Stage 1+Flex Fuel

Peak Power is achieved at 30% ethanol content

  • Intake Requirements : 

  • Exhaust Requirements: Stock exhaust or upgraded cat-back exhaust

  •  

  • Boost Target:

    • 91 Octane 95 RON Minimum: ~21 psi peak boost pressure tapering down to 16~ psi as you approach the 6800RPM redline, +/- ~1.5psi.

    • 93 Octane 98 RON Minimum: ~22 psi peak boost pressure tapering down to ~16psi as you approach the 6800RPM redline, +/- ~1.5psi.

    • Ethanol: As much as an additional 2psi peak boost pressure with the most at 30% ethanol (E30)

These maps are optimized for use with a stock fuel system. The stock fuel system is maxes out with a blend of E30 (30% ethanol). Ethanol content beyond E30 will trigger a custom COB13 DTC, indicating power output has been reduced.




Stage2



Stage 2 Maps

  • CARB EO: D-660-34

  • Intake Requirements : 

  • Exhaust Requirements: Stock exhaust or upgraded cat-back exhaust

  • Intercooler: AMS Performance Front Mount Intercooler (CARB under D-825-3)

  • Drivetrain: Upgraded Clutch or DSG Software Recommended

  • Boost Targets: 

    • 91 Octane 95 RON Minimum: ~25 psi peak boost pressure tapering down to ~17psi as you approach the 6800RPM redline, +/- ~1.5psi.

    • 93 Octane 98 RON Minimum: ~27 psi peak boost pressure tapering down to ~18psi as you approach the 6800RPM redline, +/- ~1.5psi.




 

Non-Performance Maps

Anti-Theft Mode

  • Will not allow vehicle to start



Valet

  • Fuel Requirements: 91 octane or better

  • Intake Requirements: Stock airbox and stock air filter

  • Exhaust Requirements: Stock exhaust

  • Boost Targets: Mechanical minimum

  • Rev Limiter: 3000RPM

*Not intended for aggressive driving*




COBB CCF Settings by Slot on Accessport

5000RPM




 

Revision Notes: 

Revision #

Notes:

Revision #

Notes:

v302

Initial Flex Fuel Release

v301

Back end improvements

v201

Fixed error in CCF RPM Limiter

v200

 Updated for backend improvements.  Fixed bug where CCF adjustments sometimes didn't work via AP

v103

Fixes for factory impulse combustion

v102

Initial release, revised ignition timing, primary fueling and boost levels for performance and safety.



Copyright 2024 © COBB Tuning Products LLC. All Rights Reserved. | www.cobbtuning.com