Supported Vehicles:

• USDM 2008-2015 Evolution X GSR/MR
  

All other world market vehicles have Stage 0 maps only

Current Map Revision:

• Anti-Theft v600

• Stage0 v600

• Stage1 v600
  

Required Accessport Firmware: 

• AP3-MIT-002: 1.7.4.0-17852 or greater
  

COBB Custom ECU Features

• COBB Custom Features: Map Switching On Mitsubishi

Hardware Requirements:

Calibrations can be used on vehicles that maintain stock turbochargers and a stock fuel system. No 3rd party intake system is confirmed to work with these calibrations. Specifics noted below, per map file.

Fuel Requirements:

Each map lists the minimum required octane. A higher octane fuel can be used safely on a map designed for lower octane. DO NOT use maps designed for higher octane with lower octane fuels. Top Tier gasoline should be used where available.

• Maps designated with "93" are for use with 93 and 94 octane/98 RON fuel or better.

• Maps designated with "91" are for use with 91 and 92 octane/95 RON fuel or better.

• Maps designated with "ACN91" are for use with 91 octane fuel found in Arizona, California, and Nevada or better. And additionally for those in Canada, for use with 94 octane Fuel at a minimum.

These maps are designed for E10 fuel (fuel with 10% ethanol content). For those who only have access to E0 fuel (fuel with 0% ethanol) it is recommended to use the "91" and "ACN91" octane versions of the maps and datalog the car to ensure your fuel is performing to the necessary level. This is especially important for those using Canadian 94 octane E0 fuel. 

Stock Hp/TQ
Tuned HP/TQ

Results may vary. Power as tested on 2013 Evolution X MR (93 octane fuel). Generally speaking, MR models will make less power than GSR models due to drivetrain losses (transmission differences).

Map Version Notes:

Stage 1 Maps (Map0 – Performance, Map1 – Economy)

• Stage 1

  • Boost Control Solenoid: Stock with stock restrictor pills

  • Exhaust Requirements: Stock (aftermarket cat-back will not affect tune)

  • Intake Requirements: Stock airbox with stock air filter

  • Boost Targets: 23.5 PSI peak tapering down to 17 PSI by the 7000 RPM redline (+/-1.5 PSI)
    

• Stage1+CHFF

  • Boost Control Solenoid: Stock with stock restrictor pills

  • Exhaust Requirements: Stock (aftermarket cat-back will not affect tune)

  • Intake Requirements: Stock airbox with COBB high flow filter (panel filter)

  • Boost Targets: 23.5 PSI peak tapering down to 17 PSI by the 7000 RPM redline (+/-1.5 PSI)
    

• Stage1+SF

  • Boost Control Solenoid: Stock with stock restrictor pills

  • Exhaust Requirements: Stock (aftermarket cat-back will not affect tune)

  • Intake Requirements: COBB SF Intake

  • Boost Targets: 23.5 PSI peak tapering down to 17 PSI by the 7000 RPM redline (+/-1.5 PSI)

Non Performance Maps

• Valet Mode

  • Rev limiter set to 4600 RPM. Boost set to wastegate spring pressure.

• Anti-Theft Mode

  • This map will not allow the vehicle to start.

• Economy Mode

  • Bundled with performance map and found in secondary map slot (Map1)

• Stage0

  • A map with stock calibration values intended for an otherwise stock Evolution X

  • Stock ignition, timing, and boost control
    

Closing Warnings and Precautions:

• Use of inappropriate calibration/modification combinations will promote engine damage

• Seek the help of a professional COBB Protuner should your Evolution X fall outside of OTS map requirements.

• Top Tier gasoline should be used where available. Use of lower quality fuels can result in catastrophic engine damage.
  
  

Revision Notes: