8F2600 - Raptor Accessport Mount

2017 - 2020 Ford F150 Raptor

Congratulations on your purchase of the COBB Tuning F150 Raptor Accessport Mount! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.

Parts List

Dual T Accessport Harness Adapter
Aluminum Spacer
Ball Mount Adapter
Mount Shaft
m6 x 1 75mm long stainless bolt
m6 washer
m5 Allen Key

Hand Tools

Accessport Mounting

Using your trim tool remove the cover over the lower bolt hole.
Using your 10mm socket remove the lower bolt.
Place the washer onto the bolt, then pass on the ball socket (with the ball facing outward) then the spacer.
Install this assembly into the bolt hole using your provided M5 hex key.
now loosen up the clamp and install it over the socket on the vehicle side and install the t-adapter before tightening it down a little ways.
Now Position it out of the way of the levers and steering wheel.
You're all done! Go out and enjoy!