How To: Change Datalog Monitors
Applicable Model/Year:
- All Vehicles
How To Enable:
This feature comes pre-enabled on all Accessport-compatible vehicles.
V3
Steps to Use:
How To Change Number Of Parameters Displayed
- Link your Accessport to your vehicle and turn it on.
- Select "Gauges" from the main menu
- Go up and select "Setup"
- Select "Configure Datalogging"
- Select/de-select parameters you want to be logged
- When finished simply hit the back button to return to the gauges
How to Change Datalogged Monitors
- Link your Accessport to your vehicle and turn it on.
- Select Gauges from the main menu
- Go up and select Settings, then go to Configure Datalogging
- You'll now see a list of monitors to select or deselect at will. If you exceed what the ECU is capable of logging at a reasonable rate, the AP will give you a warning message to remove parameters. Some parameters may take more memory to log than others.
- On the monitor select screen you can also scroll up to Setup for a few options.
- Select Clear monitors to clear all
- Reset to Defaults to go back to the default
- Save a Datalog Preset Saves your current logged items so you can load it again later.
- Load a Datalog Preset lets you load a custom log list you saved, or were sent by a tuner/COBB and loaded onto the AP through Accessport Manager
- When finished simply hit the back button to return to the gauges
V2
- Navigate to the "Monitor" menu
- Select "Set Data Log List"
- Select/deselect monitors to datalog.
- Press the Cancel button to exit. A prompt is shown to confirm or cancel changes.
