Applicable Model/Year
- AP3-SUB-003
- 2008-2014 USDM STI CCF
- 2008-2014 USDM WRX MT CCF
- 2007-2008 USDM FXT MT CCF
- 2007-2012 USDM LGT MT CCF
- 2007-2009 USDM LGT SPEC B CCF
- AP3-SUB-004
- 2015-2021 USDM STI CCF
- AP3-AU-SUB-003
- 2008-2014 ADM STI CCF
- 2008-2014 ADM WRX CCF
- AP3-AU-SUB-004
- 20082015-2014 2021 ADM STI CCF
Note | ||||
---|---|---|---|---|
| The VA Subaru WRX using the FA20 engine is
| |||
The 2014-2015 Forester XT, 2015+ Subaru WRX, and the 2019+ Ascent are not included in this feature as it uses a different ECU that already has a significantly faster logging ratethese ECUs already log via CAN. |
Applicable Firmware Versions
AP3-SUB-001: 1.7.4.2-21686+- AP3-SUB-002: 1.7.4.2-21686+AP3-SUB-003: 1.7.4.2-21686+
- AP3-SUB-004: 1.7.4.2-21686+AP3-SUB-005: 1.7.4.2-21686+
- AP3-AU-SUB-003: 1.7.4.2-21686+
- AP3-AU-SUB-004: 1.7.4.2-21686+
How To Enable:
In order for CAN logging to be available on vehicles the map must be based off of the latest CCF vehicle ECU in AccessTuner version 4.0.0+21406.25905 or greater
- Current CCF Map
- A map already based on a CCF ROM will just need to be resaved in Accesstuner and flashed to the vehicle to pick up the higher logging rate
- A map already based on a CCF ROM will just need to be resaved in Accesstuner and flashed to the vehicle to pick up the higher logging rate
Current Standard ECU Type
- These vehicles will have to have a map made in the CCF ROM in order to pick up the update.
How do I know if this feature is enabled?
To figure out which kind of logging/map you have, you can utilise our feature shown here: Subaru Vehicles: How to tell what features are enabled on your map