Versions Compared

Old Version 6

changes.mady.by.user Brandyn Mowat

Saved on

compared with

New Version Current

changes.mady.by.user Brandyn Mowat

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Table of Contents

How To: Change Datalog Monitors




Applicable Model/Year: 

  • All Vehicles



How To Enable:

This feature comes pre-enabled on all Accessport-compatible vehicles.



V3


Steps to Use:

How To Change Number Of Parameters Displayed

  1. Link your Accessport to your vehicle and turn it on.
  2. Select "Gauges" from the main menu
  3. Go up and select "Setup"
  4. Select "Configure Datalogging"
  5. Select/de-select parameters you want to be logged
  6. When finished simply hit the back button to return to the gauges

How to

Clear/Reset

Change Datalogged Monitors

Excerpt
  1. Link your Accessport to your vehicle and turn it on.

  2. Select
"
  1. Gauges
" from
  • Select "Configure Datalogging"
    • Go up and select "Setup"
    1.  from the main menu

      Image Added

    2. Go up and select
    "Settings"
    1. Settings, then go to Configure Datalogging

      Image Added

    2. You'll now see a list of monitors to select or deselect at will.  If you exceed what the ECU is capable of logging at a reasonable rate, the AP will give you a warning message to remove parameters.  Some parameters may take more memory to log than others.

      Image Added


    3. On the monitor select screen you can also scroll up to Setup for a few options.
      1. Select Clear monitors to clear all
    , or "
      2. Reset to Defaults
    " to
      1.  to go back to the default
    monitor list
      2. Save a Datalog Preset Saves your current logged items so you can load it again later.
      3. Load a Datalog Preset lets you load a custom log list you saved, or were sent by a tuner/COBB and loaded onto the AP through Accessport Manager
    2. When finished simply hit the back button to return to the gauges





    V2

    1. Navigate to the "Monitor" menu




    2. Select "Set Data Log List"




    3. Select/deselect monitors to datalog.



    4. Press the Cancel button to exit. A prompt is shown to confirm or cancel changes.



    Related Articles:

    How To: Datalog