Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

846665 - Subaru Redline Fuse Box Cover VB WRX

2022 - 2024 WRX




Congratulations on your purchase of the COBB Tuning Subaru Redline Fuse Box Cover! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.




Table of Contents


Table of Contents



Parts List

Image Removed
Expand
titleRedline Fuse Cover
Driver Side

Image Added


Expand
titleRedline Fuse Cover Passenger Side

Image Added


Expand
titlePre-Cut Adhesive Sheet


Tools Needed

Misc.

  • Hands
  • Soap
  • Water
  • Towel





Section 1

  1. Park your car in a flat, level area and allow it to cool down properly.

  2. Locate your fuse box boxes in the engine bay.




  3. If itthey's re dirty (Like ours) take it off of the car by depressing the clips and lifting.  Then wash it thoroughly .  If you use soap make with soap and water, making sure to get all the soap residue off of the cover.  In many cases a dilution of alcohol may work better., and allow it to dry completely before proceeding

    Image Added


  4. Remove the cover from the foam it came in and flip it upside down, setting it on top of the foam.

    Image Added    Image Added


  5. Pop the center out of the adhesive sheet




  6. The larger gasket will go on the big cover, while the smaller inner part of the gasket will match up with the smaller cover.  Line it up on with the depression indentation on the inside of the fusebox.
    Image Removedlids to make sure of the orientation.  Armed with the knowledge, remove the backing from the side that will go towards the cover and stick it down in place.

    Image Added    Image Added



  7. Remove the side of the adhesive that is towards the cover and attach it to the cover pressing down firmly.
    Press it down on top of the factory fuse coverand hold down for two seconds before letting go.

    Image Added


  8. Remove the top layer covering the adhesive to expose the sticky side

    Image Added

  9. Drop the factory covers down into the carbon piece and gently press in the area where the adhesive is.

    Image Added


  10. You're all done!  Go out and enjoy
    Image Removed

    Image Added    Image Added

    Image Added    Image Added






Insert excerpt
PRS:Contact Us:
PRS:Contact Us:
nopaneltrue