5V2400 - MQB ABS Heatshield
Congratulations on your purchase of the COBB Tuning Volkswagen MK7 Catback / Downpipe. The following instructions will assist you through your installation process. Please read them first BEFORE beginning the install and familiarize yourself with the steps and tools needed. If you feel that you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.
Parts List
Downpipe
- Heat Shield
- (2) Speed Nuts
Tools Needed
- Ratchet
- Sockets: 13mm
- 6mm Hex Socket
- Optional: Exhaust Hanger Removal Tool, Silicone Lubricant
- O2 Sensor Removing Tool
Table of Contents | ||
---|---|---|
|
Installation of COBB Volkswagen MK7 Turboback
- With the downpipe out of the way, remove the factory plastic ABS module heat shield. This should pop off from the module itself.
- Next, remove the upper and front lower ABS module mounting nuts as well as the screw on metal clip holding the O2 sensor wiring. Place the Cobb heat shield over these bolts and tighten back down.
Insert excerpt | ||||||
---|---|---|---|---|---|---|
|