812300

COBB TUNING SUBARU 4 Bar MAP Sensor

Subaru WRX 2002 - 2007
Subaru STI 2004 - 2019
Subaru FXT 2004 - 2008

Congratulations on your purchase of the COBB Subaru 4 Bar MAP Sensor! The following instructions will assist you through your installation process. Please read them first BEFORE beginning the install and familiarize yourself with the steps and tools needed. If you feel that you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.

Part List

COBB 4 Bar MAP Sensor
2 x Hex Screws
2 x Locking Washers

Tools Needed

3mm Hex Key
Phillips Head Screwdriver

Removing the Factory MAP Sensor

With the hood of your vehicle open, locate the factory MAP Sensor located on the top of the throttle body.
Unclip the connector from the factory sensor by pressing down on the tab at the rear of the connector.
Using a phillips head screwdriver, remove the two screws securing the factory sensor.
Pull straight up to remove the sensor, it may require a bit of force due to the o-ring.