Congratulations on your purchase of the COBB Subaru 4 Bar MAP Sensor!The following instructions will assist you through your installation process. Please read them first BEFORE beginning the install and familiarize yourself with the steps and tools needed. If you feel that you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.
COBB 4 Bar MAP Sensor
2 x Hex Screws
2 x Locking Washers
3mm Hex Key
Phillips Head Screwdriver
Removing the Factory MAP Sensor
With the hood of your vehicle open, locate the factory MAP Sensor located on the top of the throttle body.
Unclip the connector from the factory sensor by pressing down on the tab at the rear of the connector.
Using a phillips head screwdriver, remove the two screws securing the factory sensor.
Pull straight up to remove the sensor, it may require a bit of force due to the o-ring.
Installing COBB 4 Bar MAP Sensor
Insert the COBB 4-Bar MAP Sensor, being careful not to damage the o-ring.
Use a 3mm hex key to install the provided screws with locking washers
Plug in the connector, making sure to verify it is locked into position.