552202 - Mitsubishi Catted Mid-Pipe [Discontinued]

552202 – Mitsubishi Catted Mid-Pipe

Mitsubishi Evolution X GSR, MR, Final Edition 2008 - 2015

Mitsubishi Lancer Ralliart 2009 - 2015

Congratulations on your purchase of the COBB Tuning Catted Mid-Pipe! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.

IMPORTANT! Installing this kit will require custom tuning or utilizing an appropriate Stage Power Package map if you have a matching mechanical configuration. Please consult with COBB or an authorized ProTuner in your area if you have any questions!

Table of Contents

Parts List

  • COBB Mid-pipe.

Tools Needed

Hand Tools

  • Phillips head screwdriver
  • Flathead screwdriver
  • 3mm Allen Key
  • 7mm Nut Driver
  • Trim removal tool
  • Pick

  • Needlenose pliers

  • Channel Lock Pliers

  • Deadblow Hammer


  • Oxygen Sensor Wrench


  • (2) 17mm combination wrench
  • (2) 19mm combination wrench

Stock Component Removal

Exhaust components can often become locked in place so it's a good time to spray your bolts and oxygen sensors with a penetrating oil.

  1. Park your car in a smooth, flat area and properly lift and support it.

  2. Using a 22mm oxygen sensor wrench remove the oxygen sensor.  Be careful not to damage the wiring.

  3. Unloop the wiring from the connectors that take it underneath the exhaust.


  4. Unbolt the side exhaust hanger using a 12mm wrench.

  5. Loosen the two 19mm nuts going from the downpipe to the factory mid-pipe.  Leave the nuts on loosely for now to give you the support to loosen the remaining bolts.


  6. Loosen the two 19mm rear bolts of the mid-pipe.  Once they're both moving easily you can remove both of the bolts entirely.


  7. With the rear bolts removed, you can remove the front bolts and remove the entire mid-pipe from the car.

COBB Mid-pipe Installation

  1. Transfer the stock exhaust hanger along with the hardware over to the new mid-pipe.

  2. Bolt the pipe into place using your stock gaskets.


  3. Apply a small amount of antiseize to the threads of the oxygen sensor then reinstall.

  4. Since the sensor has been relocated to the other side of the pipe, the wiring is now too long, you can either zip tie it into the protective cage it has underneath the car, or carefully pull some of the slack into the inside of the car where it comes through the floor underneath the seat.

  5. Flash an appropriate map onto the car.

  6. You're all good!  Go out and enjoy.


Contact Us:

COBB Customer Support

Web Support and Tech Articles: COBB Tuning Customer Support Center

Email: support@cobbtuning.com

Phone support available 9am to 6pm Monday-Thursday. 9am to 4pm Friday (CST)


return to www.cobbtuning.com

Copyright 2023 © COBB Tuning Products LLC. All Rights Reserved. | www.cobbtuning.com