COBB Custom Features: Burnout Mode on Ford Vehicles


How To: Burnout Mode Ford Vehicles


Applicable Model/Year: 

  • Focus ST 13-18
  • Fiesta 14-19
  • Mustang Ecoboost 15-17

How To Enable:

This mode comes pre-enabled on all new maps.  If you find it is not working, make sure you are on the most recent map and firmware versions.


Steps to Use:

Automatic Transmission Vehicles

  1. If equipped with drive mode, set the drive mode to "Track".
  2. Hold the traction control button down for ~6 seconds to disable Advancetrac.
  3. Set the shifter into the "S" selector and tap the "-" paddle to engage manual shifting mode.
  4. Hold your left foot on the brake.
  5. Hold the "OFF" or "ON/OFF" cruise control button to activate.
  6. Push the accelerator pedal down all the way.
  7. You're now spinning the tires!
  8. Modulate the burnout with your left foot, We also recommend shifting into 2nd gear.
  9. Once the tires are warm, release the brake, accelerator pedal, and the burnout button!

Manual Transmission Vehicles

  1. If equipped with drive mode, set the drive mode to "Track".
  2. Hold the traction control button down for ~6 seconds to disable Advancetrac.
  3. Press and hold the clutch all the way in, and put the car into 1st gear.
  4. Hold the "OFF" or "ON/OFF" cruise control button to activate.
  5. Push the Accelerator pedal down to the floor and release the clutch.
  6. Immediately after releasing the clutch, place your left foot on the brake pedal.
  7. Modulate the burnout with your left foot.
  8. Once the tires are warm, release the brake, accelerator pedal, and the burnout button!


Available Adjustments and How to Make them:

All adjustments for burnout mode must be done in the Accesstuner Pro software.  They can be found under the "Burnout" folder in the "RPM Features" section of the "COBB custom features" folder.

  • Burnout Mode Exit Speed
    • This is the maximum amount of speed the vehicle is allowed before exiting burnout mode.  Once the undriven wheel speed reaches the exit speed OR the burnout button is no longer held burnout mode will deactivate and standard limiters will be active.
  • Burnout Mode Rev Limit
    • Once the RPM in this setting is reached the engine will be limited via fuel or throttle cut.
  • Configure Burnout Mode (Base)
    • This setting activates the use of Burnout Mode. 0=Disabled, 1=Enabled
  • Configure Burnout Mode (Strategy)
    • This selects between the type of RPM limiting used in burnout mode.  Throttle cut is less abusive than fuel cut and cause less wear and tear.  Fuel cut allows for boost and puts more power into the tires in the event that you have problems getting the tires to spin.


Things To Look Out For:

WARNING - BURNOUT MODE IS ABUSIVE TO THE ENGINE, CLUTCH, TRANSMISSION, AXLES, TIRES, AND DIFFERENTIAL.  THE USER ACCEPTS ALL RISKS AND RESPONSIBILITIES WHEN USING THIS FEATURE



Link Dump





Copyright 2023 © COBB Tuning Products LLC. All Rights Reserved. | www.cobbtuning.com