844660 - Subaru Redline Fuse Box Cover GR, VA WRX, STI

2008 - 2021 WRX, WRX STI

Congratulations on your purchase of the COBB Tuning Subaru Redline Fuse Box Cover! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.

Parts List

Redline Fuse Cover

Pre-Cut Adhesive Sheet

Tools Needed

Misc.

Hands
Soap
Water
Towel

Section 1

Park your car in a flat, level area and allow it to cool down properly.
Locate your fuse box in the engine bay.
If it's dirty (Like ours) take it off of the car by depressing the clips and lifting. Then wash it thoroughly. If you use soap make sure to get all the soap residue off of the cover. In many cases a dilution of alcohol may work better.
Remove the cover from the foam it came in and flip it upside down, setting it on top of the foam.
Pop the center out of the adhesive sheet
Line it up on the depression on the inside of the fusebox.
Remove the side of the adhesive that is towards the cover and attach it to the cover pressing down firmly.
Press it down on top of the factory fuse coverand hold down for two seconds before letting go.
You're all done! Go out and enjoy