Congratulations on your purchase of the COBB Tuning Intake System for the Fiesta ST! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.
Removing Factory Intake
Installing the COBB Intake
Using the smallest clamp (#44), install the 2.5" - 3" Coupler onto the turbo inlet and slip a #48 clamp over it.
Make sure that your hose clamps are clocked so that they do not rub on anything. The ones on the coupler going to the turbo inlet in particular can be clocked in a fashion that they rub on other components of the engine bay causing damage. |
Once you're happy with the position of the tube, tighten down the hose clamps (8mm or screwdriver) followed by the bracket bolts that support the tube (10mm).
Make sure that your hose clamps are clocked so that they do not rub on anything. The ones on the coupler going to the turbo inlet in particular can be clocked in a fashion that they rub on other components of the engine bay causing damage. |
We found newer cars were more fairly likely to have the hood prop be in the wrong orientation when you go to install. Make sure it's oriented so that the prop itself fits into the retainer built into the radiator shroud. |
Main Installation Instruction Repository for Fiesta Parts
Link to Fiesta Map Notes to see what map you should be on given the parts you've added