5F2200 - Ford Raptor Downpipes
2017 - 2020 Ford Raptor
Congratulations on your purchase of the COBB Tuning Raptor Downpipes! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.
IMPORTANT! Installing this kit will require custom tuning or utilizing an appropriate Stage Power Package map if you have a matching mechanical configuration. Please consult with COBB or an authorized ProTuner in your area if you have any questions!
3/8" ratchet
3/8" 12" extension
3/8" 6" extension
3/8" Socket Swivel
3/8" 8mm socket
3/8" 10mm socket
3/8" 13mm socket
3/8" 14mm socket
In order to remove the restrictive stock flanges, you'll need to remove the factory studs holding them in place. To do so, use the provided stud remover. Simply place it over the stud and tighten it down by spinning the rear section to the left, making sure to keep it centered. With it in place attach a 3/8" ratchet to the back and carefully loosen it off. Use of an impact is not advised as this threads directly into the turbocharger and any damage to the housing or threads can be a large issue to fix.
It may be worth spraying the studs down with penetrating fluid in order to prevent damage to the turbocharger. |
Ford Raptor & F-150 Limited HO Map Notes
Helps to figure out which map you should be on given the parts installed to your car