752150 - Evo X Air box
2008-2015 Mitsubishi Evo X
Congratulations on your purchase of the COBB Tuning Evo X Intake System. The following instructions will assist you through your installation process. Please read them first BEFORE beginning the install and familiarize yourself with the steps and tools needed. If you feel that you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.
Part List
Sheetmetal Airbox
Tools Needed
Start by removing the two plastic Phillips head fasteners from the factory intake duct.
To remove the factory air box you will now need to remove the 10mm bolt located on the lower front side of the box.
4. Now unclip the MAF sensor connector and the two plastic clips that secure the MAF sensor harness to the air box using a pair of needle nose pliers.
5. Now loosen the 10mm bolt on the hose clamp that secures the turbo inlet tube to the MAF sensor housing and you should be able to lift the factory airbox and MAF sensor housing up and out.
6. At this point using a small flat head screwdriver you will want to unclip the wire harness from the factory air box bracket as it will contact the COBB intake bracket. You also have to remove the entire factory air box bracket (two 12mm bolts as shown) as it is would interfere with the COBB intake.
(Where Applicable)