9C1760 - COBB R35 GT-R Lowering Springs
09-12 GT-R
Congratulations on your purchase of the COBB Tuning GT-R Lowering Springs! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.
3/8" ratchet
3/8" 10mm deep socket
3/8" 12mm deep socket
14mm combination wrench
17mm O-ratchet or specialty "notched" Socket
Deadblow Hammer
3/8" 12" extension
3/8" 6" extension
NOTE: The factory springs do not have a great amount of preload, however it might be a good idea to use a spring compressor for precautionary reasons.
NOTE: The factory springs do not have a great amount of preload. However it might be a good idea to use a spring compressor for precautionary reasons.
NOTE: Don’t forget to reconnect the damper connector wire.