Congratulations on your purchase of the COBB TuningF150 Stock Placement Front Mount Intercooler! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.
3/8" 12" extension
3/8" 6" extension
3/8" 10mm socket
3/8" 13mm socket
Remove the 4 13mm bolts holding at the front and 2 15mm bolts in the rear of the skid plate in place, watch out for the brace in the rear and note the orientation it was in when removed as it will only fit in that way when you go to reinstall.
The clips with built in nuts found on the frame can fall off easily, so make sure not to lose them!
Reach up and undo the wiring to the fans by gently squeezing the clip before disconnecting them. Then disconnect harness from fan using your trim tool.
Remove the two wiring connectors on the fan and intercooler where they are attached.
With the piping connected loosely, push the intercooler the rest of the way up into the mount, making sure that the rubber mounts sit inside the holes in the mount above. If your vehicle has the intercooler fans equipped, you'll want to tuck the top pins into the upper mount before pushing the intercooler all the way up as the fans fit around the intercooler in a "U" shape.
The Intercooler fans have two different sized rubber pins that it sits on. They are sized specifically for the upper vs lower mount so make sure you have it oriented in the proper direction.
Install the supplied CARB sticker on an easily viewable space that won't be susceptible to large amounts of heat. We recommend on the radiator core support, or the underside of the hood.