Part Number – Part Name

Vehicle Coverage

[placeholder]

Congratulations on your purchase of the COBB Tuning xxxxxxxxxxxxx! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.

IMPORTANT! Installing this kit will require custom tuning or utilizing an appropriate Stage Power Package map if you have a matching mechanical configuration. Please consult with COBB or an authorized ProTuner in your area if you have any questions!

Section 1

Park your car in a flat level area
Bring the top back 100mm
Remove the wind screen between the seat backs by depressing the buttons on each side.
Peak through the rear corners and find where the cables are attached and unhook them on each side.
With the cables uninstalled you can open the lid slightly more and pop the retaining strap free.
With a friend holding the rear glass up slowly bring the top back until you can get the strap over the corner in order to hold the glass up and out of the way.
Now go ahead and pull the carpeting free from the roof storage area.
With the carpeting removed you should now be able to easily see the heat insulating pad, go ahead and remove that as well.
Remove the 12 T27 bolts holding the hatch in place.
Remove the hatch from the car.
Remove the T25 screws holding the airbox down and remove the two clips that hold the fresh air intake to it before removing the airbox lid from the car.
Pull the old filter out making sure any dirt or debris trapped in it doesn't fall inside.
Replace the filter with your new one.
Reinstall everything in the reverse order of removal.