Versions Compared

Old Version 22

changes.mady.by.user Brandyn Mowat

Saved on

compared with

New Version 23

changes.mady.by.user Brandyn Mowat

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.




Supported Vehicles:

  • USDM 2008-2015 Evolution X GSR/MR

    ***All NON-USDM vehicles contain Stage 0 maps only***


Current Map Revision:

  • Anti-Theft v500Theft v600
  • Stage0 v500Stage0 v600
  • Stage1 v500Stage1 v600


Required Accessport Firmware: 

  • AP3-MIT-002: 1.7.4.0-17852 or greater

COBB Custom ECU Features




Map Availability: Download from the COBB Tuning Evolution X OTS Map Database 



 Hardware Requirements:


Calibrations can be used on vehicles that maintain stock turbochargers and a stock fuel system. No 3rd party intake system is confirmed to work with these calibrations. Specifics noted below, per map file.


Warning

All calibrations will require the use of an upgraded fuel pump relay for safe operation. Details ARTICLE: Evo X Fuel Pump Relay Replacement




  • Fuel Requirements:

    Each map lists the minimum required octane. A higher octane fuel can be used safely on a map designed for lower octane. DO NOT use maps designed for higher octane with lower octane fuels. Top Tier gasoline should be used where available.

    • Maps designated with "93" are for use with 93 and 94 octane/98 RON fuel or better.
    • Maps designated with "91" are for use with 91 and 92 octane/95 RON fuel or better.
    • Maps designated with "ACN91" are for use with 91 octane fuel found in Arizona, California, and Nevada or better. And additionally for those in Canada, for use with 94 octane Fuel at a minimum.


    These maps are designed for E10 fuel (fuel with 10% ethanol content). For those who only have access to E0 fuel (fuel with 0% ethanol) it is recommended to use the "91" and "ACN91" octane versions of the maps and datalog the car to ensure your fuel is performing to the necessary level. This is especially important for those using Canadian 94 octane E0 fuel. 







Note

Maximum gains are measured as the largest gain at any single point between the two plots.


Typical Stage1 gains vs Stock Power: 


Peak GainMax Gain
Stage1 93 

+13% HP / +10% TQ

+13% HP / +14% TQ

Stock HP TQ 
Stage1 93 (98 RON) HP TQ

Peak Gains are measured as the absolute maximum value between the highest points of two plots. 
Max. Gains are measured as the average maximum value between the highest and lowest point of two plots. 

Results may vary. Power as tested on 2013 Evolution X MR (93 octane fuel). Generally speaking, MR models will make less power than GSR models due to drivetrain losses (transmission differences).












Map Version Notes:

Info
iconfalse

Note: All performance maps are equipped with 2-way map switching. Performance maps are by default loaded into the first map slot and an economy map is loaded in the second map slot. 




Stage 1 Maps (Map0 – Performance, Map1 – Economy)

  • Stage 1
    • Boost Control Solenoid: Stock with stock restrictor pills
    • Exhaust Requirements: Stock (aftermarket cat-back will not affect tune)
    • Intake Requirements: Stock airbox with stock air filter
    • Boost Targets: 23.5 PSI peak tapering down to 17 PSI by the 7000 RPM redline (+/-1.5 PSI)
  • Stage1+CHFF
    • Boost Control Solenoid: Stock with stock restrictor pills
    • Exhaust Requirements: Stock (aftermarket cat-back will not affect tune)
    • Intake Requirements: Stock airbox with COBB high flow filter (panel filter)
    • Boost Targets: 23.5 PSI peak tapering down to 17 PSI by the 7000 RPM redline (+/-1.5 PSI)
  • Stage1+SF
    • Boost Control Solenoid: Stock with stock restrictor pills
    • Exhaust Requirements: Stock (aftermarket cat-back will not affect tune)
    • Intake Requirements: COBB SF Intake
    • Boost Targets: 23.5 PSI peak tapering down to 17 PSI by the 7000 RPM redline (+/-1.5 PSI)


Info
iconfalse

Notes: The additions of any other hardware may cause the vehicle to perform poorly 



Non Performance Maps

  • Valet Mode
    • Rev limiter set to 4600 RPM. Boost set to wastegate spring pressure.
  • Anti-Theft Mode
    • This map will not allow the vehicle to start.
  • Economy Mode
    • Bundled with performance map and found in secondary map slot (Map1)
  • Stage0
    • Intended for an otherwise stock Evolution X
    • Stock ignition, timing, and boost control


Closing Warnings and Precautions:

  • Use of inappropriate calibration/modification combinations will promote engine damage
  • Seek the help of a professional COBB Protuner should your Evolution X fall outside of OTS map requirements.
  • Top Tier gasoline should be used where available. Use of lower quality fuels can result in catastrophic engine damage.


Revision Notes: 
 

Version#Notes:
v600
  • Maps Uprevved for Parity
v500
  • Maps were resaved to pickup backend improvements
  • Maps have been updated to eliminate unnecessary DTC suppression.
v404
  • Bug fixes for 13-15 GSR and FE vehicles.
v403
  • Further refinements to enhance drivability and address lean/overboost issues.
  • Adjustments to idle tables to cure erratic idle issues.
  • Adjustments made to alleviate detonation during takeoff.
v402
  • Further refinements to enhance drivability and address lean/overboost issues.
  • Adjustments made for customers experiencing limp mode issues.
  • Tip in transient changes to help address take off issues (MR).
  • Timing changes to address vehicles registering knock when coming from a stop.
  • Lean spool disabled to ensure proper air fuel ratio when coming into boost.
  • General small fuel and timing changes
v401
  • Finalized map strategy for USDM 2011-2013 Evolution X GSR/MR vehicles.
  • Disabled Knock Flash (CEL Flash) by default.
  • Addressed shifting issues associated with EVO X MR models.
  • Added map support for Stage1, Stage2, and Stage3 map packages.
v400

Limited Beta map support released with new 2-Way Switching strategy.

v107

This calibration was updated to match the latest performance map revisions and includes corrections made to stabilize idle.

v106

This calibration was updated to match the latest performance map revisions and Includes Cranking Enrichment table settings from the newer 2010 models.

v105

This calibration was updated to match the latest performance map revisions.

v104

The Torque Monitor function has been defeated.

v101

Maps updated to match latest performance map strategy.

v100

Original Calibration. Adjusted boost, fuel, ignition, camshaft phasing and base programming logic to improve driving quality and performance. Revised Closed Loop management for improved driving quality. Smoothed out boost related values, improved boost response at lower RPM. Altered intake camshaft phasing parameters in an effort to improve low and midrange torque and boost response. Smoothed ignition advance mapping for low and mid RPM response.