| Note |
|---|
These instructions work for the following models
- WRX 2002 - 2007
- WRX STI 2004 - 2020
- Forester XT 2004 - 20092008
|
- Locate your stock bypass valve.
- Using a pair of pliers, remove the return line from the bypass valve.
- Remove the vacuum line from the factory bypass valve.
Using a 12mm socket with ratchet, remove the 2 bolts that hold the bypass valve in place and remove it from the car. | Info |
|---|
| TIP: Make sure to keep an eye on the factory gasket behind the BPV. It can fall when you remove the valve and end up in difficult to reach locations! |
- Remove the bypass valve.
- Remove breather tubes from intercooler. Dikes can be helpful when removing the metal clamps or zip ties.
- Loosen the turbo outlet clamp using a screwdriver or appropriately sized socket (Typically 7-8mm) along with the (2) throttle body clamps using a screwdriver or 8mm socket.
- Remove the two bolts holding the intercooler in place
 
- Gently wiggle TMIC free from engine bay by sliding it back and then out. Be careful to not damage your windshield wiper cowl.
|