8G4600 – Accessport Mount for Ford F-150 MY17-22
2017 - 2021 F150/Raptor
Congratulations on your purchase of the COBB Tuning Accessport Mount! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.
Table of Contents
| Table of Contents |
|---|
Parts List
| Expand | ||
|---|---|---|
| ||
|
| Expand | ||
|---|---|---|
| ||
|
| Expand | ||
|---|---|---|
| ||
|
| Expand | ||
|---|---|---|
| ||
|
| Expand | ||
|---|---|---|
| ||
|
| Expand | ||
|---|---|---|
| ||
|
| Expand | ||
|---|---|---|
| ||
|
| Expand | ||
|---|---|---|
| ||
|
| Expand | ||
|---|---|---|
| ||
|
Tools Needed
Misc.
- Included Allen Wrenches
Installation and Assembly
| Expand | ||
|---|---|---|
| ||
|
- Park your car in a flat, level area
- Locate the M6 x 1 x 35 Bolt, M6 Flat washer and the Ball mount. Slip the bolt through the washer and then into the mount.
- Using your M5 Hex Key, install the ball mount into the rear portion of the mount halves.
- Grab the Double Ball End Clamp and attach it to the ball you just assembled, and the ball mount to t-slot adapter.
- Slip the correct insert adapter over the grab handle (See Below). Match the angled and flat sides of the adapter to the handle dimensions.
2017-2020 F-150 / Raptor - Mount #416
2021 F-150, Raptor - Mount #400
- Pop the pre-assembled mount onto the bushing, keeping it beetween the two ribs on the mount. Then using your M3 Hex Key and the two M4 x 0.7 x 12 Socket head bolt, install the front part of the mount hand tight.
- Rotate everything around so that you're happy with where the Accessport sits, then you're all done! Go out and enjoy!
| Insert excerpt | ||||||
|---|---|---|---|---|---|---|
|