Supported Vehicles:
Audi A3 (8V) USDM
Sedan
6-speed Quattro 2015-2018
7-speed FWD 2017-2018
Cabriolet
6-speed Quattro 2015-2018
7-speed FWD 2017-2018
Map Revision:
Map | Revision |
---|---|
Stage0 | v302 |
Required Accessport Firmware:
AP3-VLK-002: 1 1.7.4.02-18492 or greater24849
Info |
---|
For more information on CARB Exemption Orders for this vehicle as well as the actual letter check out our page CARB EO numbers for COBB VW Products |
COBB Custom ECU Features:
These cars offer a variety of added features such as launch control and traction control. For more information check out our guide COBB Custom Features: Volkswagen MQB Platforms
Warning |
---|
We've noticed a few simple issues can cause flashing your car to fail so it's critical to watch out for these problems.
|
Fuel Requirements:
Each map lists the minimum required octane. A higher octane fuel can be used safely on a map designed for lower octane. DO NOT use maps designed for higher octane with lower octane fuels. Top Tier gasoline should be used where available.
Maps designated with "91 OCT or 95 RON " are for use with 91 and 92 octane/95 RON fuel or better.
Maps designated with "93 OCT or 98 RON" are for use with 93 octane/98 RON fuel or better.
94 octane with 0% Ethanol should run the ACN91 Map.
Note |
---|
Running 0% Ethanol Fuels These maps are designed for E10 fuel (fuel with 10% ethanol content). For those who only have access to E0 fuel (fuel with 0% ethanol) it is recommended to use the "91" and "ACN91" octane versions of the maps and datalog the car to ensure your fuel is performing to the necessary level. This is especially important for those using Canadian 94 octane E0 fuel. |
Stage1
Appsplus tabs lite macro | ||
---|---|---|
|
Appsplus tabs lite macro | ||
---|---|---|
|
Stage1
Intake Requirements :
stock air filter
Stock airbox with drop-in replacement,
COBB SF Intake 7V2150COBB Redline CF Intake 7A1100
Exhaust requirements : Stock exhaust or upgraded cat-back exhaust (2014-2017), upgraded cat-back exhaust (2018-2019)
Boost Target:
91 Octane 95 RON: ~22.5 psi peak boost pressure tapering down to ~13 psi as you approach the 6800 RPM redline, +/- ~2 psi
93 Octane 98 RON: ~23.5 psi peak boost pressure tapering down to ~14 psi as you approach the 6800 RPM redline, +/- ~2 psi
Stage1+Flex Fuel
E## refers to the ethanol content (E) in % (##). So in the case of E10, it is 10% ethanol (Pump gas is typically between 7 & 15%)
Appsplus tabs lite macro | ||
---|---|---|
|
Appsplus tabs lite macro | ||
---|---|---|
|
Stage1+Flex Fuel
Peak Power is achieved at 30% ethanol content
Intake Requirements :
stock air filter
Stock airbox with drop-in replacement,
Exhaust requirements : Stock exhaust
Fueling Requirements: COBB Flex Fuel Upgrade Kit 3V2650
Boost Target:
91 Octane 95 RON: ~22.5 psi peak boost pressure tapering down to ~13 psi as you approach the 6800 RPM redline, +/- ~2 psi
93 Octane 98 RON: ~23.5 psi peak boost pressure tapering down to ~14 psi as you approach the 6800 RPM redline, +/- ~2 psi
Ethanol: As much as an additional 2psi peak boost pressure with the most at 30% ethanol (E30)
Panel | ||||||||
---|---|---|---|---|---|---|---|---|
| ||||||||
These maps are optimized for use with a stock fuel system. The stock fuel system is maxes out with a blend of E30 (30% ethanol). Ethanol content beyond E30 will trigger a custom COB13 DTC, indicating power output has been reduced. |
Stage 2
Warning |
---|
Drivetrain ConsiderationsRunning a Stage 2 map on a vehicle without an upgraded clutch or DSG tune may cause slipping or damage to your clutch/clutch pack. |
Revision Notes:
Expand | ||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||||||
|
Insert excerpt | ||||||
---|---|---|---|---|---|---|
|