[placeholder]512510, 514510 –Subaru Turbo Heatshield
Subaru Impreza WRX 2002 - 2014
Subaru Impreza 2.5GT 2009
Subaru Forester XT 2004 - 2008
Subaru WRX STi 2004 - 2021
Subaru Legacy GT, Spec B 2005 - 2009
Subaru Outback XT 2005 - 2009
Subaru Forester XT 2009 - 2013
Congratulations on your purchase of the COBB Tuning
Subaru Heatshield! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.
IMPORTANT! Installing this kit will require custom tuning or utilizing an appropriate Stage Power Package map if you have a matching mechanical configuration. Please consult with COBB or an authorized ProTuner in your area if you have any questions!
Table of Contents
Table of Contents |
---|
Parts List
- COBB Subaru Heatshield
- (2) m6 x 12mm Hex Bolt
- m6 x 16mm Hex Bolt
- (3) m6 Fender Washer
Tools Needed
Sockets
3/8"
3/8" Socket Swivel
- 3/8" 7mm socket
- 3/8" 16mm socket
- 3/8" 17mm socket
- 3/8" 18mm socket
- 3/8" 19mm socket
- 3/8" 21mm socket
- 3/8" 14mm deep socket
- 3/8" 15mm deep socket
- 3/8" T50 Torx Bit
- 3/8" E10 inverted Torx
- 3/8" E12 inverted Torx
- 3/8" E14 inverted Torx
- 3/8" E18 inverted Torx
- 3/8" 4mm Allen Socket
- 3/8" 5 mm Allen Socket 3/8" 10 mm Allen Socket
1/2"
Hand Tools
- Phillips head screwdriver
- Flathead screwdriver
- 3mm Allen Key
- 7mm Nut Driver
- Trim removal tool
- Deadblow Hammer
Misc.
Wrenches
Section 1
Remove the Top Mount Intercooler
Insert excerpt | ||||||
---|---|---|---|---|---|---|
|
Insert excerpt | ||||||
---|---|---|---|---|---|---|
|
Remove Factory Heatshield
Insert excerpt | ||||||
---|---|---|---|---|---|---|
|
Turbo Heat Shield Installation
Section 5- Hand install one of the supplied 10mm bolts along with a washer into the lower up-pipe/turbo support bracket.
- Slide the heat shield into place with the cutout over the loosened bolt on the lower mount.
- Loosely install the other two bolts on the top and inside of the heat shield.
- Slide the heat shield around a little bit to make sure the wastegate arm isn't hitting the bracket and then tighten down each bolt with a 10mm socket.
Section 3
Section 4
- Reinstall the intercooler in the reverse order of removal.
- Go out and enjoy!
Links
MAP Notes
Helps to figure out which map you should be on given the parts installed to your car
Links for related partsCalibration Map Notes for Subaru Vehicles
Insert excerpt | ||||||
---|---|---|---|---|---|---|
|