Supported Vehicles:
Map Revision:
Hardware Requirements:
Stage1 maps are intended for stock GT3 / GT3 RS models or cars with muffler bypass pipes.
Stage2 maps are intended for cars with full aftermarket exhaust systems.- NOTE: Stock and OTS maps are not compatible with iPE Exhaust systems.
Fuel Requirements:
Each map lists the minimum required octane. A higher octane fuel can be used safely on a map designed for lower octane. DO NOT use maps designed for higher octane with lower octane fuels. Top Tier gasoline should be used where available.
- Maps designated with "93" are for use with 93 and 94 octane/98 RON fuel or better.
- Maps designated with "91" are for use with 91 and 92 octane/95 RON fuel or better.
- Maps designated with "ACN91" are for use with 91 octane fuel found in Arizona, California, and Nevada or better.
- Maps designated with "E85" are for use with 85% Ethanol, 15% Gasoline fuel only.
These maps are designed for E10 fuel (fuel with 10% ethanol content). For those who only have access to E0 fuel (fuel with 0% ethanol) it is recommended to use the "91" and "ACN91" octane versions of the maps and datalog the car to ensure your fuel is performing to the necessary level. This is especially important for those using Canadian 94 octane E0 fuel.
Stage1 Factory Tune HP TQ Stage1 E85 HP TQ |
| Porsche 997.1 GT3 / GT3 RS | Peak Gains | Max Gains |
|---|---|---|
| Stage1 E85: | +11.7% HP, +7.0% TQ | +14.8% HP, +15.0% TQ |
Stage1
- Intake: Stock Intake, optional aftermarket air filter
- Exhaust: Stock Exhaust System
Peak Gains are measured as the absolute maximum value between the highest points of two plots.
Max. Gains are measured as the average maximum value between the highest and lowest point of two plots. Thin line is measured horsepower and bold line is measured torque.
Stage2 Factory Tune HP TQ |
Stage2 ACN91 HP TQ |
Stage2 93 HP TQ Stage2 100 HP TQ |
| Porsche 997.1 GT3 / GT3 RS | Peak Gains | Max Gains |
|---|---|---|
| Stage2 ACN91: | +3 HP, +1% TQ | +3% HP, +4% TQ |
| Stage2 93: | +4% HP, +1% TQ | +7% HP, +6% TQ |
| Stage2 100: | +6% HP, +3% TQ | +8% HP, +7% TQ |
Stage2
Factory Tune HP TQStage2 ACN91 HP TQ
Stage2 93 HP TQ
Stage2 100 HP TQ- Intake: Stock Intake, optional aftermarket air filter
- Exhaust: Aftermarket Catted Exhaust System
Peak Gains are measured as the absolute maximum value between the highest points of two plots.
Max. Gains are measured as the average maximum value between the highest and lowest point of two plots. Thin line is measured horsepower and bold line is measured torque.
Map Version Notes:
Stage 1
Exhaust Requirements: Stock or with Muffler BypassStage 2
- Exhaust Requirements: Full Aftermarket Exhaust. Porsche Cup headers can be used.
- Intake Requirements: Stock air box with stock air filter
- Left Foot Braking is enabled.
- Rev Limit is raised to 8550 in all performance calibrations.
Non Performance Maps:
Valet Mode
- Rev limiter set to 4000 RPM.
Stage 0
- Stock calibration. No changes made at all.
- NOTE: Stock and OTS maps are not compatible with iPE Exhaust systems.
Closing Warnings and Precautions:
- Use of inappropriate calibration/modification combinations will promote engine damage.
- Seek the help of a professional COBB Protuner should your Porsche fall outside of OTS map requirements.
- Top Tier gasoline should be used where available. Use of lower quality fuels can result in catastrophic engine damage.
- For track events, we recommend adding at least 2 gallons of 100 octane fuel to battle high track temperatures.
Map Revisions:
| Map Version: | Notes: |
|---|
V102 Map description fixes.
V101 Map maintenance update for future feature support.
| v102 | Map Description Fixes |
| v101 | Background improvements |
| v100 | Original Calibration. Adjustments made to Ignition Timing, Throttle Limits, Air Fuel Ratios, Rev Limit, Left Foot Braking and torque limits |
. |