8F2650 Ford 2.3l Turbo Blanket

Ford Ecoboost Mustang 2014 - 2019

Ford Focus RS 2017 - 2018

Congratulations on your purchase of the COBB Tuning Turbo Blanket! The following instructions will assist you through the installation process. Please read them BEFORE beginning the install to familiarize yourself with the steps and tools needed. If you feel you cannot properly perform this installation, we HIGHLY recommend you take the vehicle to a qualified and experienced automotive technician.

Table of Contents

Parts List

• COBB Turbo Blanket
• (2) Springs
• Safety wire

Tools Needed

Sockets

3/8"

• 3/8" ratchet

• 3/8" 12" extension

• 3/8" 6" extension

• 3/8" 13mm socket
  

• 3/8" T20 Torx Bit

• 3/8" T25 Torx Bit

• 3/8" T30 Torx Bit

• 3/8" T40 Torx Bit

Hand Tools

• Needlenose pliers

Stock Heatshield Removal

1. Using a 13mm socket remove the top two turbo mounting bolts holding the top of the heat shield in place.
   
   Image Added
   
   
   
2. Remove the 13mm bolt holding the damper on to the engine mount.  While not strictly necessary, it does give you a little bit more room to try and get the lower heat shield bolt out.
   
   Image Added    Image Added
   
   
   
3. Remove the T-25 lower bolt attaching the heat shield in place.  If it stripped like ours, removing the motor mount will allow additional room to get in there and work at getting it off of the car.
   
   Image Added

Section 2

Section 3

Section 4

Section 5

Links

MAP Notes

Helps to figure out which map you should be on given the parts installed to your car 

Links for related parts